D200-101-00
1
I56-3888-105
DESCRIPTION
The LT FL01 Series is part of the Fire Alarm Aspiration Sensing
Technology
®
(FAAST) family. FAAST is an advanced fire detection
system for use where early warning and very early warning are a
requirement. The system continuously draws air from the controlled
environment through a series of sampling holes to monitor the
environment for smoke particulate.
The FL01 is the stand-alone version of the FAAST LT range and is
available in 3 different models:
FL0111E -
Has single channel capability with one laser smoke
sensor.
FL0112E -
Has single channel capability with two laser smoke
sensors in a common chamber for coincidence
detection.
FL0122E -
Has two channel capability with two laser smoke
sensors in separate chambers. (One sensor for each
channel).
This guide provides information for mounting and basic installation
using the unit’s default factory settings. For more extensive
information please see the FAAST LT Advanced Setup and Control
Guide - reference D200-100-00.
SPECIFICATIONS
Electrical Characteristics
Voltage Range:
18.5 - 31.5 VDC
Supply Current:
1 Channel:
170mA (typical); 360mA (max) @
24 VDC 25
o
C (excluding sounders)
2 Channel:
270mA (typical); 570mA (max) @
24 VDC 25
o
C (excluding sounders)
Configurable Input: Activation Time:
2s (min)
Relay Contact Ratings:
2.0 A @ 30 VDC, 0.5A @ 30 VAC
Environmental Ratings
Temperature:
-10°C to 55°C
Relative Humidity:
10% to 93% (non-condensing)
IP Rating:
65
Mechanical
Exterior Dimensions:
See Figure 1
Wiring:
0.5 mm² to 2 mm² max
Maximum
Single
Pipe Length:
100m (Classes B & C)
Maximum
Branched
Pipe Length:
160m (2 x 80m, Class C)
Maximum Number of Holes:
See Table 1A
Pipe Spec (EN54-20 Compliance):
to EN 61386
(Crush 1, Impact 1, Temp 31)
Outside Pipe Diameter:
25mm (nom) or 27mm (nom)
Shipping Weight:
6.5kg (inc sensors)
FIRE ALARM ASPIRATION SENSING TECHNOLOGY
®
QUICK INSTALLATION GUIDE
STAND-ALONE FAAST LT MODELS FL0111E FL0112E FL0122E
Figure 1: Dimensions and Knock-Outs
E N G L I S H
PARTS LIST
Description Quantity
FAAST LT unit
1
Mounting bracket
1
3-pin Terminal block
6
4-pin Terminal block
1
2-pin Terminal block
3
47 k-ohm EOL Resistor
2
USB Cable
1
Front Panel Labelling Pack
1
Wiring Diagram Label
1
Installation Kit CD
1
Quick Installation Guide
1
Important Note
Aspirating Smoke Detectors supplied and installed within the
EU must conform to the EU Construction Products Regulation
(CPR) 305/2011 and the related European Product Standard EN
54-20. FAAST LT has been tested and certified to ensure that it
conforms to the necessary Standards, but strict adherence to this
instruction guide is advised to ensure that the installation meets
the requirements of the CPR.
Warning
The performance of this system is dependent upon the pipe
network. Any extension or modification to the designed
installation may cause improper operation. The operational
effects of such changes need to be verified using the PipeIQ
2 design software.
367 mm
135 mm
56 mm
44 mm
403 mm
356 mm
50 mm
50 mm
60 mm
110 mm
I 56- 3888- 105
