ATP2410 User Manual (Version 4.0.0.0)
Page 6
Chapter 2 Installation
2.1 Package List
ATP2410 Series Recording Server *1, with a 500G 2.5-inch hard disk
Foot Bracket*2, Rubber Foot Pad*4, Screw for Foot Bracket*8
User Manual *1
+19V DC Power Supply *1
2.2 Installation Procedure
Step 1: Connect the +19V DC power line.
Step 2: Connect the network cable.
Step 3: Plug one end of a phone line into an RJ11 jack for the corresponding channel
on the recording server and connect the other end parallelly to any position
between the PBX and the telephone.
Figure 2-1 Line Connection
Step 4: Check the state of the channel connected in Step 3 through the OLED display.
If the channel is in the state ID (Idle), it indicates the connection is normal;
otherwise, the channel is not available, and you should check if there is
something wrong with the connection.
Step 5: Modify the IP address through the configuration buttons on the recording
server. For detailed instructions, refer to
. (Note: The IP
address can also be modified through the WEB interface, refer to
detailed instructions and default IP values.)
Step 6: Type in the IP address set in Step 5 into the browser and enter the Recording
Management Software. For detailed instructions about login, refer to
.
Step 7: Check through the WEB interface if the hard disk is formatted. If not, format it
before use. For detailed instructions about formatting the hard disk, refer to
2.3 Quick Guide
After completing the above steps, you can well run the recording server. The default values of the
main recording parameters are listed here below.
Recording Start Condition: Voltage
4 3 2 1
Ch
1
1
b
Ch
1
1
a
PBX
Phone
Ch
1
1
a
Ch
1
1
b