Synetik ErgoCare TOM5 STREETER, Руководство пользователя

Страница: 20 / 33

19
Calf Rest
1-
Loosen the two hex bolts located on the rear side of footrest slider bar and remove the
footrest.
2-
Install the calf rest, secure it into position and insert the bolts into the assembly holes.
3-
Reinstall the footrest into the correct position and tighten both hex bolts.
Basket-HD (Steel)
1-
Screw the attachment adaptors for the Basket-HD onto the rear axle.
2-
Attach the basket to these adaptors with the screws.
3-
Secure the basket with the belts and with the Velcro in the front part of the stroller.
Tilt-lock for Spastic
1-
Unscrew the backrest recline-adjustment lever.
2-
Put tilt-lock into the groove where the lever is moving and put the second part of tilt-lock
onto the screw of the lever.
3-
Screw the lever back on.
Grab-Bar Bracket Cover
1-
Put the plastic plug onto the grab bar bracket.
2-
Install the elastic cover and fasten the rubber band onto the plastic nut located under the
seat
3-
Repeat the same procedure on the other side.
Extended Side Protection
Mounting –
1-
Slip the extended side protection over the backrest and onto the tubes of the push handle
from both sides with the help of the four plastic loops.
2-
The upper loops go between plastic sleeve on the push handle and the handle knob.
3-
The flaps of the extended side protection are secured with Velcro fastener.
4-
The lower part of the extended side protection is secured with strips.
Seated Position –
1-
In a seated position, it is important that the extended side protection is criss-crossed
at the rear of the backrest and secured with a strap and Velcro lock.
2-
This strap runs through plastic triangles near the upper loop and is secured with a
Velcro fastener.
Semi-seated Position –
1-
The extended side protection is secured with a strap and with a Velcro fastener that
runs through a plastic triangle.
Flat Position –
1-
Leave the extended side protection loose.