Recovery Steps
Chapter 7: Recovery Procedure
Reboot the E10
600034-01A
SNAP Connect E10 User Guide
Page 52
Finally repeat the same procedure to choose file
uImage-400000.bin
, specify address
0x400000
, and send the last file. The screen shown in
Figure 7-12
appears.
Figure 7-12: Last File Transfer Complete
Step 13: Reboot the E10.
Manually reboot your E10 by removing power, waiting a few seconds, then reapplying
power.
After rebooting the E10, it automatically boots up into a Linux system with a root
username of
root
and an empty password (just press
<Enter>
for the password field).
Now that you have restored *A* version of Linux and regained access to your E10, you
will probably want to load the latest version of the Synapse software. For more
information, refer to the chapter
Upgrade Procedures
on page 37.
Step 14: Reassemble your E10.
When reassembling your E10, notice that the circuit board slides into the
second
slot from
the bottom (not the lowest slot). Reinsert the board and reattach both end plates. Your unit
is now restored to the original operating software.