Symmetricom, Inc.
bc620/627AT Time and Frequency Processor
6-1
CHAPTER SIX
INPUT AND OUTPUT SIGNALS
6.0 GENERAL
This chapter describes the input/output connectors located on the bc620/627AT rear panel. The
jumper options are also described.
6.1 CONNECTOR I/O
The bc620/627AT has two rear panel connectors, J1 and J2. J1 is a 15 pin DS type connector
which carries most of the I/O signals. J2 is a high density DP type connector used for RS-422
serial I/O, and signal lines which accommodate an optional GPS signal suite for the bc627AT.
Table 6-1
J1 Pinouts
Signals On J1 15 Pin “DS”
Signals On J2 15 Pin “DP”
Pin
Signal
Pin
Signal
1
External 10 MHz input.
1
RS-422 Rx(+).
2
Ground.
2
RS-422 Rx(-).
3
Strobe Output.
3
RS-422 Tx(+).
4
1 PPS Output.
4
RS-422 Tx(-).
5
Time Code Output (AM).
5
Ground.
6
External Event Input.
6
Not Used.
7
Time Code Input (AM).
7
GPS 1 PPS.
8
Ground (Recommended
Time Code Return).
8
GPS 1 PPS RS-422 Rx(+).
9
Oscillator Control Output.
9
GPS 1 PPS RS-422 Rx(-).
10
Time Code Input (DCLS).
10
Ground.
11
Time Code Output
(DCLS).
11
GPS RS-422 Tx(-).
12
Ground.
12
GPS RS-422 Tx(+).
13
1,5,10 MHz Output.
13
GPS +12 VDC.
14
External 1 PPS Input.
14
Ground.
15
Periodics Output.
15
GPS +12 VDC.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com