symbios logic J21971S-0398, Руководство по установке

Страница: 14 / 86

Preparing the Data Center Cabinet
About Support Rails and Blank Panels
4 MetaStor Command Module Installation Guide Revision A, March 1998
Preparing the Data Center Cabinet
Before installing the command module in a Data Center cabinet, you
must prepare the cabinet. Preparation may include:
●
Turning off the main power
●
Removing external cabinet panels
●
Installing a set of support rails
●
Changing the SCSI ID settings on the drive modules or other
devices in the cabinet
This section lists some of the things you should check or do before
you begin installing a rackmount command module.
About Support Rails and
Blank Panels
To install the command module in a Data Center cabinet, you will
need two kits: a rackmount support rail kit and a blank panel kit.
Placement of support rails and blank panels in or on the cabinet
depends on where you intend to position the command module.
Support rail kits are available from your local dealer. Kits are
shipped separately. Each kit contains the following parts:
●
One pair of rackmount support rails
●
16 (10-32 x ½) Phillips screws
●
4 (6-32 x 3/8) Phillips screws (non self-tapping)
●
2 (6-32 x 3/8) Phillips screws (self-tapping)
For installing the support rails in the Data Center cabinet for the
command module, you will need the following parts from the kit:
●
One pair of rackmount support rails
●
12 (10-32 x ½) Phillips screws
●
4 (6-32 x 3/8) Phillips screws (non self-tapping)
Also available from your local dealer, blank panel kits contain the
following parts:
●
One 1.75-inch blank panel with mounting bracket
●
One 3.5-inch blank panel with mounting bracket
●
One 5.25-inch blank panel with mounting bracket
●
10 (10-32 x ½) Phillips screws