Symantec Veritas Cluster Server 5.0 Update 3, Руководство по установке

Страница: 122 / 176

Table 7-1
Tasks that are involved in adding a node to a cluster (continued)
Reference Task
See “Preparing for a manual installation when adding a node”
on page 123.
See “Installing VCS RPMs for a manual installation”
on page 124.
Install the software
manually.
See “Adding a license key” on page 125. Add a license key.
See “Setting up the node to run in secure mode” on page 126. For a cluster that is
running in secure mode,
verify the existing security
setup on the node.
See “Configuring LLT and GAB” on page 128. Configure LLT and GAB.
See “Adding the node to the existing cluster” on page 130. Add the node to the
existing cluster.
See “Starting VCS and verifying the cluster” on page 131. Start VCS and verify the
cluster.
Setting up the hardware
Figure 7-1 shows that before you configure a new system on an existing cluster,
you must physically add the system to the cluster.
Adding and removing cluster nodes
Adding a node to a cluster
122