4
FIXING
HOLES
MOUNTING
1. Screw the sounder on the wall and check if the tamper works properly;
2. Insert the connecting cables through the holes located on the sounder base;
3. If necessary, modify the default settings by acting on the DIP Switches as shown in the charts;
4. Connect the sounder to the alarm control panel as shown in picture 2;
5. Connect the power supply and the battery to the alarm control panel;
6. Close both internal and external covers using the screws provided.
7. Battery must have UL94-HB flammability rate;
8.
Power supply must be of SELV type.
Attention:
not to have condensation in the sounder, it is important to avoid any air flow inside the duct.
To such purpose, once the sounder is connected, seal the hole using some silicon or any other plaster.
This operation prevents condensation from forming inside the sounder; condensation mostly appears
in winter and it is usually caused by warm and humid air coming out of the wall where the sounder is
installed and passing through the holes located on the sounder base.
PICT 1
PICT 2
ANTI-FOAM CONNECTOR
(ECO 800 LS/ECO 800 LSX models)
TAMPER
CONNECTOR
