Food Waste Bio-Digester
operator
manual
REVISION: 09/2014 | page 8 of 16
4.2.4 Carefully slide the appliance forward on the pallet so that the appliance edge overhangs by approximately
200mm (8 inches).
4.2.5 Tighten two of the four adjustable legs into the transit bolt fixing holes.
4.2.6 Carefully TILT APPLIANCE FROM BASE and slide out pallet. DO NOT LIFT MOULDED APPLIANCE TOP.
4.2.7 Tighten final two adjustable legs to the rear transit bolt fixing holes.
4.2.8 Gently lower appliance.
4.2.9 Dispose of the pallet responsibly, or return to Mechline for reuse.
4.2.10 Peel off the plastic protective film from the outer panels.
4.2.11 Position the appliance relative to any other equipment to which it is to be connected. Ensure the machine is not
yet connected to the electrical supply.
The appliance is to be floor mounted and requires the following clearances:
Top: 600mm (24 inches) for lid opening
LHS: 600mm (24 inches) for service access, if available*
RHS: 600mm (24 inches) for service access, if available*
*
NOTE:
In many locations space to the sides of the appliance may not be available. This will not
adversely affect the operation of the appliance, but it may be necessary to move the machine
forward in order to gain access for service.
Rear: 90mm (3
1
/
2
inches)
4.2.12 Ensure that the reset buttons and emergency stop button are easily accessible.
4.2.13 The appliance must be placed on a flat, level and stable surface that is able to support the machine.
4.2.14
Place a 5L (1.3 US gallons) box of bio-fluid in the fluid chamber and connect as per the instructions on
the fluid box.
