Operating Instructions
6
Quick start
The quick start enables you to start the device quickly for many applications.
See the relevant sections of the operating instructions for further information.
Installation
1. Distance from the vessel wall > 200 mm, the antenna should project into
the vessel by more than 10 mm.
2. Ensure that you do not fall below the minimum socket diameter depending on
the socket length.
3. Follow the sealing instructions.
For further information see the section entitled "
Installation
".
Electrical connection
1. Ensure that the voltage supply is identical to the details on the model plate.
2. Connect the device as shown in the following figure:
For further information see the section entitled "
Connect to the voltage supply
".
Set the parameters
1. Go to the "
Setup
" menu using the display and control module.
2. Using the "
Medium
" menu point select the medium for your application, for
example "
Powder / Dust
".
ca
. 10 mm
200 mm
(7.87")
Fig. 2: Connection chamber for twin chamber housing for mains voltage
1 Internal connection to connection chamber
2 For display and control module or interface adapter
5 6 7 8
4...20mA
2
1
2
+
( )
(-)
1
Fig. 1: Distances between the antenna and the vessel wall / roof
