
Other
Clear Battery used – reset the value to zero. This allows the pilot
to determine how much battery life is remaining.
Adjust Temp – Used to calibrate the temperature reading on the
engine. Unless there is an issue adjustments are not normally
needed.
Temp Unit – set to Fahrenheit or Centigrade
Pump Unit – set DC pump or brushless pump
Firmware Version – Displays the current version firmware for the
following engine controls:
TCU – Turbine control Unit
ECU – Engine Control Unit
GSU – Ground Screen Unit
Test function menu
Press “OK” to access test functions
Test Pump – depress OK and hold OK to increase pump speed. Pump
increases gradually. Test pump initiates fuel solenoids
simultaneously. Be careful not to flood the engine.
Test Fuel Valve – press “OK” to activate fuel valve.
Test Gas Valve – press “OK” to activate Gas Valve – this controls fuel
to the glow plug.
Test Glow Plug – press “OK” to activate Glow Plug circuit. A glow can
be seen from the rear of the motor.
Test Starter – Press “OK” to activate starter. Use this function to
manually cool the motor. RPM speed of starter is set in the startup
menu
Data chart
Record running data use the increment and decrement key to step
through events in the data chart.ECU can record 34 minutes of
running data.
The color corresponding to each parameter as follows
Red – Temp
Yellow – Throttle position
light blue – Pump
Green – RPM
Dark Blue – Power voltage