OFFSET ADJUSTMENT HANDLE
1)
To Calibrate the Offset
Control Handle, place
the handle to “C” Center
position and lock in
place as shown in
FIGURE 15.1
2)
Set the Flow Control
Handle to Setting “4”
(Fully Opened).
3)
When standing at the rear of the Spreader
looking into the Hopper, see which hole is
not fully Open. If both holes are not fully
opened then follow the
“Flow Control
Calibration”
Steps on
page16
. If only one
hole is partially covered, take note as to
whether it is the right hole or the left hole. If
both holes are fully open, no adjustment is
needed.
15
FIGURE 15.2
Opening Holes
CONTROL CALIBRATION
4)
Go back to the Offset Control Handle and
locate the Linkage rod as shown in
FIGURE 15.3
.
5)
Using a 7/16”& 1/2” open end wrench,
loosen the jam nuts at both ends of the rod.
One nut is left-hand thread and one is
right-hand thread.
6)
Once the jam nuts are loose and moved
away from the ball joint, turn the rod to
lengthen or shorten the linkage. If the left
hole was covered then shorten the linkage.
If the right hole was covered then lengthen
the linkage. Adjust rod as necessary until
both holes are fully opened.
7)
Once both holes are fully opened re-
tighten the jam nuts.
GENERAL RECOMMENDATIONS
•
Calibrate the controls with an empty hopper.
•
It is easier to have two people when calibrating the control
linkages. One person to watch the slide plates and the other person
operating the controls and making the necessary adjustments.
•
It is recommended to calibrate the controls often to ensure proper
functionality of the slide plates.
Wrench
Qty. Size
(2) 1/2”
(1) 7/16”
Tools Required
:
Pliers
(Optional)
FIGURE 15.3
Offset Control Handle Linkage
FIGURE 15.1
Содержание HOBBY FARM PRO 22000
Страница 34: ...34 When ordering replacement parts USE PAINT CODE TK BLACK NOTES...
Страница 35: ...35 When ordering replacement parts USE PAINT CODE TK BLACK NOTES...
Страница 36: ...36...
Страница 37: ...37...
