Swim & Fun ClearWater Pro 1002, Руководство пользователя

Страница: 55 / 92

MV-1001-1002-1044-09-2016 . Swim & Fun Scandinavia . info@swim-fun.dk . www.swim-fun.com
© All rights reserved Swim & Fun Scandinavia ApS 2016
Page 55
8.5 Important installation information
We recommend the use of PVC pipe and PVC connections when carrying out the installation.
(They must always be installed by a professional).
Alternatively, PE pipe is used, if placed subterraneanly. Note that a ball valve must be attached to
the suction hose with raw water and another attached to the pressure hose with cleansed water.
The sand filtering device must be kept completely erect (on a flat level).
Note:
If the suction hose is short, the suction time will be reduced and the pump’s capacity increased.
Observe:
The hoses and the pipes must be completely impervious as the pump’s capacity will be
impaired if air is allowed into the suction hose. This may also be harmful.
Electrical installation must be carried out by a qualified electrician who has to consider
the above-mentioned safety zone of the pool.
8.6 Waste
You can help preserve our environment. Always dispose of consumed electrical equipment correct -
ly at your local recycling station.
8.7 Winter storage
When the swimming pool is prepared for winter, the filter and the pump must always be entirely
emptied, detached and stored in a dry and frost-proof room before the first frost arrives! Otherwise,
there is a risk of frost damage that is not covered by the warranty. On the same occasion, set the
seven-way handle to the winter position (position 7), as this relieves the pressure on the handle’s.
9. Troubleshooting
Problem Cause Solution
The pressure gauge shows
pressure in excess of 1.0 bar
Dirty filter sand. Carry out a backwash.
Pressure is too low The pre-filter basket is dirty. Clean the pre-filter basket.
Air in the pump’s pre-filter The gasket around the seven-way valve
is dirty and leaky.
Detach the seven-way valve from the filter
lid and clean the gasket.
Water escapes from the
backwash valve
The gasket around the seven-way valve
is dirty and leaky. Grit in the gasket.
Detach the seven-way valve from the filter
lid and clean the gasket.
Pervious filter Damaged gasket. Examine the gasket and exchange it for a
new one if necessary.