Swim & Fun ClearWater Pro 1002, Руководство пользователя

Страница: 45 / 92

MV-1001-1002-1044-09-2016 . Swim & Fun Scandinavia . info@swim-fun.dk . www.swim-fun.com
© All rights reserved Swim & Fun Scandinavia ApS 2016
Page 45
2.2 Installation diagram
1. Filter tank
2.
Pump
3. Attachment hose between six-way
valve and pump
4. 7-way overhead valve
5. From pool (uncleansed). Shown
with practical lock valve installed
on the pump’s hose (not included)
6. To the pool (cleansed water).
Shown with practical lock valve
installed on the hose after the sand
filter (not included)
7. Backwash for emptying unclean water.
8. Filter opening (with pressing ring)
9. Pressure gauge
10.
Outlet valve – placed on the side.
11. Bottom outlet/open outlet channel
12. Two openings to UV light and / or
water heater
Aggregate diagram for the entire sand filtering device
3. Connecting to power source
Observe:
At flexible mains connection to an electrical power source, HO5RN-F is used (indoors)
or HO7RN-F (outdoors).The smallest diameter is 1,5 mm or something close to it. At
permanent connections with wires, only plastic-coated NYM wires or wires of similar
quality may be used.
When the filtering system is used outdoors, it needs to be connected to an outdoor power source
of 230 V 1 N–AC 50 HZ. The power source must be at least 3.5 m from the edge of the pool and
must always be installed by a qualified electrician. Installation with filter sand and flexible pool hos -
es or PVC pipe. The power source must always have earth connection and be connected to an
HFI/HPFI-device.