Swim & Fun ClearWater Pro 1002, Руководство пользователя

Страница: 54 / 92

Page 54
MV-1001-1002-1044-09-2016 . Swim & Fun Scandinavia . info@swim-fun.dk . www.swim-fun.com
© All rights reserved Swim & Fun Scandinavia ApS 2016
8.1 When installing filtering systems in pump well close to the pool
The well should be large enough to enable all maintenance on the filtering system to be carried out
unobstructed. All other instructions are given under 4.2
Observe:
At the installation it is important that the pump well is not directly exposed to splashing
water from the pool or rain water.
The well should be well-ventilated to avoid condensation that over time could damage
the pump through corrosion.
Note:
The manufacturer is not responsible for damage stemming from installation and usage
in areas that are intended for housing, nor for damage stemming from poor floor drain -
ing or other drainage systems.
8.2 Installation in plant room
Requirements for plant room:
• Power source: 230V
• Floor drainage: The floor should have an inclination that will allow water to be led
away and discharged.
• Open drainpipe connection: The diameter of the drainpipe should be at least Ø100 mm
• Bottom tank for pump: If the drainpipe is higher than the re-rinsing valve, a bottom tank of at
least 0.6 x 0.6 x 0.6 m should be built. A suitable pumping device
should also be positioned at the installation site.
The floor of the plant room may not be higher than the swimming pool’s water line. If the filtering
device is positioned above the water line, a return pipe stop must be attached to the suction hose
from the pool. The difference in height may never exceed 1.5 m.
8.3 Requirements for the building
The floor of the plant room should at a minimum have a water-repellent covering and incline to -
wards the drain. The room’s ventilation must be adequate.
8.4 Space requirements
The sand filtering device requires an area of: 600 x 800 x 1250 mm (Breadth x Depth x Height).