Swim & Fun ClearWater Pro 1002, Руководство пользователя

Страница: 47 / 92

MV-1001-1002-1044-09-2016 . Swim & Fun Scandinavia . info@swim-fun.dk . www.swim-fun.com
© All rights reserved Swim & Fun Scandinavia ApS 2016
Page 47
Photo 4.1c Photo 4.1d
Observe:
In order to protect the filter tank and the foundation plate against possible damage, AL -
WAYS fill the filter tank with 20-30 cm of water before the filter sand is poured into the
tank! Photo 4.1c + 4.1d.
Diagram over the inside of the filter tank when the lid has been removed.
The filter material is poured into the filter tank thus: Model 1001/1044 Pro Compact is filled with 10-
12 kg sand while Model 1002 Pro is filled with circa 25 kg.
The filter material consists of special quartz sand that has been rinsed, silted up and burnt. This
filter sand must be ordered separately. Alternately, zeolite or crushed glass can be used as filter
material.
Seal the filter tank carefully. First, remove any grit and grime from the sealing jointing and grease
the O-ring with a bit of Vaseline if needed. This extends its life.
Observe:
Make sure that there is no excess filter sand in the filter tank and that there is no sand
in the clean water storage tank as this can result in sand at the bottom of the swimming
pool.
Filter bottom with small grooves
Filter chamber
Outlet valve under filter bottom
Separator wall between the filter chamber and the
cleansed water
Inlet from the filter chamber
Observe: Anchor point. This is where the filter lid
should slot into place.