Swim & Fun ClearWater Pro 1002, Руководство пользователя

Страница: 46 / 92

Page 46
MV-1001-1002-1044-09-2016 . Swim & Fun Scandinavia . info@swim-fun.dk . www.swim-fun.com
© All rights reserved Swim & Fun Scandinavia ApS 2016
4. Setup of the sand filtering system
Observe that the smallest distance between the edge of the pool and sand filtering pumps with or -
dinary 220/230 V power supply should be at least 3.5 metres according to the installation standard
C15-100.The sand filter should be placed on a steady and entirely smooth (!) surface of at least 60 x
60 cm. The site should have a draining surface consisting of pebbles, crushed concrete or the like.
The pump is self-sucking but should always be positioned below the waterline so that the water flows
to the pump of its own accord. This will considerably relieve the pressure on the pump and extend its
life.
Insert the two enclosed stainless screws, each with a tension pulley, into the drilled holes of the fil -
ter platform and fasten the pump with the nuts (the mounting piece to the suction hose/plexiglas lid
should be directed towards the left). See photos 4.a and 4.b.
Position the pump so that the mounting piece to the suction hose/plexiglas lid is directed towards the
left viewed from the side where the pump is standing at the front on the platform. The overhead valve’s
grey pump connection ”from pump” points forward in the direction towards the pump (photo 4.b). In this
connection, also check that the lid of the outlet valve at the bottom of the filter tank is fastened.
Photo 4.a Photo 4.b
4.1 Replenishment of filter materials
Open the pressing ring at the filter tank’s opening and take off the filter lid. Having done this, check
that the foundation plate and the separator wall inside the filter tank are correctly positioned. Note
that the bars on the foundation plate continue to the bars of the filter tank’s inner wall. Thereafter,
the separator plate should also be placed in these wire bars so that the upper edge of the separa-
tor plate is lying flat against the edge of the filter tank. See photos 4.1a and 4.1b.
Photo 4.1a - A plastic clamp is included Photo 4.1b
for tightening the pressing ring.