Swecoin TTP 5000, Руководство по обслуживанию

Страница: 18 / 60

TTP 5000 Series Kiosk Printer Sub-system — Service Manual Edition B, May 97 16
4. Raise the paper release lever. Until you switch OFF the printer, it will present all
transferred data both in hexadecimal notation and as ASCII characters in two
adjacent columns containing 8 bytes each. The printout is formatted for 60 mm page
width.
Switching the printer OFF and ON again resets it to normal operating mode.
3.2 Parts removal and replacement
WARNING!
DANGER OF INJURY! Depending on the position of the crank mechanism in the cutting
module, the cutting knife may start moving when the printer is switched ON.
KEEP HANDS AWAY!
CAUTION!
The printer power supply should be switched off, and the low-voltage power cable should
be disconnected from the control board before you disconnect or connect any other cable
on the control board. The printer electronics might otherwise be damaged.
CAUTION!
The printhead and some components on the control board are sensitive to ESD
(electrostatic discharges). To prevent damaging such components, observe all the usual
precautions such as keeping the part in its original packing (“ESD-bag”) until you are
ready to install the part. Do not touch its pins. Use a grounded wrist strap when handling
ESD-sensitive components.
CAUTION!
If the printer or print module is not to be used for a week or so, disengage the printhead
from the platen by lowering the paper release lever. Otherwise, both the printhead and
the platen can be deformed.
3.2.1 Control board connectors
Se page 34 (TTP 5000) or page 44 (TTP 5100, 5200, and 5250).
3.2.2 Separating the upper and lower chassis modules
1. Loosen the four screws joining the two chassis modules.
2. Disconnect the cables at the rear edge of the control board.
3. Lift the upper module slightly and disconnect cables as required from the connector
board so that you can place the upper module on its front panel in front of the bottom
module.