Swann SI9032N, Инструкция по эксплуатации

Страница: 13 / 20

Note:
a. For first use, it is normal that a slight vibrating sound may occur from
the electrical pump inside the base unit for a few seconds when steam
ironing is started. It is because there is air inside the filter. It will stop when
the air inside the filter has been pumped out. If this abnomal condition
continues to happen for more than 60 seconds, please check whether
water tank and filter is assembled correctly.
b. When set at “NYLON” position, no steam is released since dry ironing
is most suitable.
c. When fabric setting is set at “POLYESTER” / “RAYON” / “COTTON”
“LINEN”, steam will automatically vary according to sole-plate
temperature. The pump will stop working and no steam released when the
sole-plate temperature becomes too low. It will resume once reheated
to the desired temperature.
13
WWW.sWan-BranD.co.uK
Dry ironing
1. Connect the appliance to a suitable socket outlet and lay handle down. Power
indicator light (red) “ ” on iron unit will light up indicating that the unit has been
connected to the power supply.
2. Set selection button to desired position according to fabric setting chart (page 08).
Blue indicator light on iron unit will blink slowly to indicate the unit being heated
up. When the blue indicator light changes to a steady light and an audible “Bi”
signal produced, the desired temperature has been reached. During use, blue
indicator light will cycle from blinking to a steady light and then from steady
mode to ON.
3. After use, put iron unit back onto the base unit again, turn selection button to
“ ” and then unplug the appliance from main socket.
Note:
When changing your temperature setting from higher setting to lower, you
should not start ironing immediately since it may cause burns to your fabrics.
Please wait till blue indicator light lights up steadily, and then start ironing.