7
Swan Helpline Number: 0345 610 4118
Installation
For further Installation advice please see separate Assembly
Instructions sheet.
Positioning the machine
When determining the location of the appliance, take care to choose a place
where you can easily load and unload your dishes.
Do not put your machine in any location where there is the probability for the
room temperature to fall below 0°C.
Before positioning, take the appliance out of its packaging by following the
warnings located on the package.
Position the machine close to the water supply and drain.
Do not grip the machine by its door or panel in order to move it.
Take care to leave a small clearance on all sides of the machine so that you
can comfortably move it back and forth during cleaning.
Make sure that the water inlet and outlet hoses do not get crushed or twisted
while positioning the machine. Also, make sure that the machine is not on the
power cable.
Adjust the machine’s feet so that it can stand level and balanced. Proper
positioning of the machine ensures problem-free opening and closing of its
door.
If the door of you machine does not close properly, check if the machine is
stable; if not, adjust the feet and ensure its stable position.
The power socket must be easily accessible at all times.
Water connection
Ensure that the indoor plumbing is suitable for installing a dishwasher.
Water inlet hose
Do not use the water inlet hose of your old appliance. Always
use the new water inlet hose supplied with your machine. If
you are going to connect a new or long-unused water inlet
hose to your machine, run water through it to check for leaks.
Connect the water inlet hose directly to the water inlet tap. The
pressure supplied by the tap should be at a minimum of 0.03
Mpa and and at a maximum of 1 Mpa. After the connections
are made, the tap should be turned on fully and checked for