16
Bus Send Subpage
The Bus Send subpage of Stereo ST1 and ST2 is the same as Mono channel, please refer to P10. S/PDIF
and USB Channel can only be sent to Bus5~ Bus8 and Master L&R, the operation is the same as the stereo
send of Mono Channel, interface as below.
Output Stage Subpage
For this part, please refer to the Subpage of Output Stage of Mono Channel
Output busses
DM20
has 14 output busses 4 Mono (Bus1~Bus4) and 5 Stereo (Bus5~Bus8), Master L&R. By default,
BUS1-8 page shows processing stripe for Bus 1~Bus 8. When the system stays at the page of BUS1-8,
press down
“
SEL
”
, the selection button of L&F master output on the panel, to move BUS page two stripes
left and shows the channel info of Bus 3~Master L&R. If you press the
“
SEL
”
of Bus 1or Bus 2, then the
bus page will move right and shows the channel info of Bus 1~Bus 8.
The output busses processing channel consists of 4 modules--- Input Stage, EQ, Input Source and Output
Stage,which all have subpages except Input Source. Single press a module and subpage will pop up,
press the close button to exit.
23
2
Meter Page
The page contains two parts: signal level from input processing channel and outputs.
Signal level of input processing channel has three modes IN, Pre Fader and Post Fader with Pre Fader as
the default. To select signal level mode to be displayed through single pressing the button.The signal level
of output has two modesPre Fader and Post Fader with Pre Fader as the default. To select signal level mode
to be displayed through single pressing the button. On the right side of signal level of outputs you can see
the bus names which are assigned to the port.
FX page
