Swagelok TC72 series, Руководство пользователя

Страница: 16 / 22

16 Tube Cutting Tool User’s Manual
Operation
The tool should only be operated using a ground fault circuit
interrupt (GFCI) protected outlet.
Adjusting for Tube Size

CAUTION
The tube cutting tool must be switched off before
adjusting the tool The saw may revolve around the
tube automatically when it is switched on
The saw blade should not touch the tube before the cutting
operation begins. Adjust the tube facing tool according to this
section as necessary.
1. Turn the blade adjustment wheel until the saw blade housing
is at the lowest position (Fig. 20).
2. Slide the tube towards the saw blade until it is right in front
of the blade. Clamp the tube by turning the clamping jaw
adjustment wheel (Fig. 21).
3. Rotate the motor to the cutting position, approximately 45
°
clockwise.
4. Adjust the saw blade position by turning the blade
adjustment wheel until the teeth of the blade reach
approximately 0.039 to 0.079 inch (1 to 2 mm) into the tube
(Fig. 22).
5. Rotate the motor back to the original position.
6. Loosen the clamping jaw adjustment wheel and move the
tube forward until the cutting location is above the saw
blade. Fully clamp the tube by turning the clamping jaw
adjustment wheel clockwise until it stops.
Fig 22 Adjusting the Blade Position
Fig 21 Saw Blade Teeth Position
Fig 20 Moving the Saw Blade Housing
Blade adjustment
wheel
Clamping jaw
adjustment wheel