17/30
ALFA IN a.s ©
www.alfain.eu
8. FIRST STEPS
Commissioning of the machine must be in accordance with the technical data
and operating conditions.
Note
This equipment must only be used by qualified personnel.
1. Before beginning work is necessary to connect the machine to the mains.
2. Check completeness of the mounted cutting torch.
3. Fit the burner and secure the burner well by turning the nut clockwise.
4. Connect the compressed air on connector
A7
on the rear wall of the
machine.
5. Connect the compressed air on connector
A6
on the rear wall of the
machine.
6. SVAROG 105 PLASMA has a pressure regulator
A5
on the rear panel.
7. Set the pressure with the regulator on the rear panel of the machine to 5.5
bar.
8. After turning on the ON / OFF switch
A8
the display will illuminate
9. Connect the work lead cable to the material being cut and to the
connector
A1
.
10.
Check up the input air pressure (min 5,0 bar, max 8,5 bar) and make
a regulation if necessary.
11.
Set potentiometer to the cutting power you need.
12.
Fit the torch to the appropriate nozzle diameter according to the
selected cutting current.
13.
Press the trigger on the cutting torch, the pre gas will flow for 1 s.
14.
The pilot arc will start.
15.
Shift the torch with the pilot arc close to the material, the pilot arc
will change to cutting arc automatically. If you do not start cutting within
2 s, the arc will snuff off. If the torch delays during the cutting from the
material, the arc will snuff off. In case that the machine is in mode
Cutting material with gaps – switch
A5
position
, cutting arc will
change to pilot arc and if you
do not start cutting within 2 s, this arc will
snuff off.
16.
To finish the cutting process, release the torch trigger.
REQUIREMENTS
FOR SOURCE OF COMPRESSED AIR
1. Delivered air pressure must be max. 8,5 bar and min. 5,0 bar.
2. Air consumption minimal 320 l/min.
3.
Compressed air for the plasma must be clean and dry.
4.
Pressure dew point +3 °C.
5.
Maximum oil content 0.1 mg/m
3
.
6.
Maximal size of solid particles 15 microns.
