SV 258 PRO User Manual
10
Note: The producer does not recommend removing the controller without a sound reason.
Double check that the controller has a good fixation in the socket after reconnecting!
The monitoring station case is equipped with the air pressure
compensation valve that enables you to open the case easily if the
internal pressure is lower than the atmospheric one.
Use the silica gel bags (optional accessory) for absorbing any
remaining moisture after closing the lid.
The valve should be released if opening the top lid is problematic.
Note: The valve must be closed when the station is used outdoors, otherwise the case is not
sealed against moisture.
The station case is equipped with four Souriau UTO type connectors for:
•
input signals from the tri-axial piezoelectric accelerometer
(
INPUT 1-3
),
•
input signal from the microphone (
INPUT 4
),
•
powering station and charging the internal battery
(
DC SUPPLY
),
•
external
interface
for
the
digital
input/output
(
EXTERNAL INTERFACE
). In the standard station
configuration, this socket can be used for alarm signals
output (for example, SP 272
light and sound alarm).
To connect a cable to a case socket, start by lining up the key on
the plug and socket, then lock the connector by turning the ring
clockwise (only the ring close to the socket will rotate).
To disconnect a cable, push the connector towards the station and
turn it counter clockwise. New connectors require more force so
using a closed hand is more effective than using only fingers.
