Suzuki GSX1200 1999, Руководство по обслуживанию

Страница: 130 / 274

FUEL AND LUBRICATION SYSTEM 4-21
THROTTLE POSITION SENSOR POSITIONING
Install the throttle position sensor as described below.
• Measure the resistance
between the throttle position sen-
sor terminals as shown in the illustration.
% % % % %
Throttle position sensor resistance : Approx. 5 k
Ω Ω Ω Ω Ω
• Measure the resistance between the throttle position sen-
sor terminals as shown in the illustration.
• Fully open the throttle valve with the throttle lever.
• Position the throttle position sensor until resistance is
3.09 – 4.63 k
Ω
.
• When the resistance is within specification, tighten the
throttle position sensor mounting screws.
% % % % %
Throttle position sensor resistance 3.09–4.63 k
Ω Ω Ω Ω Ω
CARBURETOR ENGAGEMENT
Position the throttle valve control lever
A
between the throttle
valve synchronizing screw and spring as shown.
TROTTLE CABLE ADJUSTMENT (MAJOR ADJUSTMENT)
NOTE:
Minor adjustment can be made by the throttle grip side adjuster.
(
!
2-10)
• Remove the fuel tank. (
!
4-3)
• Loosen the lock nut
1
of the throttle returning cable.
• Turn the returning cable adjuster
2
to obtain proper cable play.
• Loosen the lock nut
3
of the throttle pulling cable.
• Turn the pulling cable adjuster
4
in or out until the throttle cable
play
C
of 2.0 – 4.0 mm at the throttle grip is obtained.
• Tighten the lock nut
3
securely while holding the adjuster
4
.
• While holding the throttle grip at the fully closed position, slowly
turn the returning cable adjuster
2
to obtain a cable slack
B
of 1.0 mm.
• Tighten the lock nut
1
securely.