Suzuki GSF650, Руководство по обслуживанию

Страница: 234 / 333

5-72 CHASSIS
• Apply grease on the recessed portion of the joint plate holder
3
and set the joint plate
0
.
NOTE:
When positioning the joint plate
0
on the tool, its stamp mark
must face the joint plate holder
3
side.
• Set the drive chain on the tool as illustrated and turn in the
adjuster bolt
5
to secure the wedge holder & wedge pin
4
.
• Turn in the pressure bolt “A”
6
and align two joint pins
A
properly with the respective holes of the joint plate
0
.
• Turn in the pressure bolt “A”
6
further using the bar
7
to
press the joint plate over the joint pins.
• Continue pressing the joint plate until the distance between
the two joint plates come to the specification.
&
Joint plate distance specification
W
$
JOINT PIN STAKING
• Set up the special tool as shown in the illustration.
1
Tool body
2
Grip handle
3
Pressure bolt “A”
4
Adjuster bolt (without hole)
5
Staking pin (stowed inside grip handle behind rubber cap)
6
Bar
NOTE:
Before staking the joint pin, apply a small quantity of grease to
the staking pin
5
.
RK 20.45 – 20.75 mm
Should pressing of the joint plate be made excessively
beyond the specified dimension, the work should be
redone using the new joint parts.