Suzuki GSF650, Руководство по обслуживанию, Страница: 233 / 333

CHASSIS 5-71
• Place the drive chain link being disjointed on the holder part
8
of the tool.
• Turn in both the adjuster bolt
6
and pressure bolt “A”
3
so
that each of their end hole fits over the chain joint pin properly.
• Tighten the pressure bolt “A”
3
with the bar.
• Turn in the pressure bolt “B”
4
with the bar
5
and force out
the drive chain joint pin
9
.
$
NOTE:
After the joint pin
9
is removed, loosen the pressure bolt “B”
4
and then pressure bolt “A”
3
.
• Remove the joint pin
9
of the other side of joint plate.
$
CONNECTING
JOINT PLATE INSTALLATION
• Set up the special tool as shown in the illustration.
1
Tool body
5
Adjuster bolt
2
Grip handle (without hole)
3
Joint plate holder
6
Pressure bolt “A”
(engraved mark “F50”)
7
Bar
4
Wedge holder & wedge pin
• Connect both ends of the drive chain with the joint pin
8
inserted from the wheel side
A
as installed on the motorcycle.
9
O-ring … 4 pcs.
0
Joint plate
Joint set part number
RK: 27620-16G20
)
Continue turning in the pressure bolt “B”
4
until the
joint pin has been completely pushed out of the chain.
Never reuse joint pins, O-rings and plates. After joint
pins, O-rings and plates have been removed from the
drive chain, the removed joint pins, O-rings and plates
should be discarded and new joint plate, O-rings and
plate must be installed.
Do not use joint clip type of drive chain. The joint clip
may have a chance to drop which may cause severe
damage to motorcycle and severe injury.
(F50)