Suzuki GSF650, Руководство по обслуживанию, Страница: 114 / 333

3-78 ENGINE
CYLINDER HEAD
• Place the cylinder head onto the cylinder block.
• Cylinder head nuts and washers must be installed in the cor-
rect position as shown.
A
Copper washer with normal nut (4 pcs.)
B
Copper washer with cap nut (4 pcs.)
C
Steel washer with normal nut (4 pcs.)
• Tighten the twelve 10-mm nuts in ascending order and to the
specified torque.
#
Cylinder head nut: 37 N·m (3.7 kgf-m)
• After firmly tightening the twelve 10-mm nuts, install the cylin-
der head bolt (6 mm)
1
and tighten it to the specified torque.
#
Cylinder head bolt: 10 N·m (1.0 kgf-m)
• Install the cam chain guide
2
as shown.
• While holding down the cam chain, rotate the crankshaft
clockwise and align the “T” mark on the signal generator rotor
with the center of the pickup coil.
$
Exhaust side
Turn the crankshaft using a 19 mm wrench. Never
rotate the crankshaft using a 6-mm T-type wrench.