Suzuki GRAND VITARA 2008, Руководство пользователя

Страница: 185 / 308

5-44
OTHER CONTROLS AND EQUIPMENT
78KS0-37E
User ID Setting
1) Press the power on/off knob (1) to turn
off the power.
2) With the numbered buttons (19) with
numbers [3] and [4] kept depressed at
the same time, press the power on/off
knob (1) for about 1 second or more.
The unit displays “SEC”.
3) With the up button (4) kept depressed,
press the numbered button (19) with
number [1].
The unit displays “- - - -”.
4) Press the numbered buttons (19) with
number [1] to [4], and enter the user ID.
Each button corresponds to each digit,
and the number increases each time
the button is pressed.
For example, to raise the digit second
from the left to 3, press the numbered
button (19) with number [2] four times.
5) Press the program type button (11) for
about 2 seconds or more to enter.
Power is switched off after the unit dis-
plays “SEC”.
Once the ID is set up, the ID is required
at power-on when this unit or the bat-
tery has been removed.
User ID Entry
Once the ID is set up, this unit displays
“SEC” to prompt you to enter your user ID
when the power is turned on again in the
case of removal of this unit or the battery.
The unit cannot be used unless the ID is
entered in the following order.
NOTE:
The unit does not display “SEC” when the
power is turned on within 20 seconds from
the last use.
1) With the up button (4) kept depressed,
press the numbered button (19) with
number [1].
The unit displays “- - - -”.
2) Press the numbered buttons (19) with
number [1] to [4], and enter the user ID.
Each button corresponds to each digit.
Enter the stored user ID.
3) Press the program type button (11) for
about 2 seconds or more to enter.
Power is switched off.
When you switch the unit back on, it is
in radio mode for normal use.
Erasing User ID
Your stored user ID can be erased. After
erasing it, you may set a new user ID.
Therefore, you can change your user ID as
often as you like.
1) Press the power on/off knob (1) to turn
off the power.
2) With the numbered buttons (19) with
numbers [3] and [4] kept depressed at
the same time, press the power on/off
knob (1) for about 1 second or more.
The unit displays “SEC”.
3) With the up button (4) kept depressed,
press the numbered button (19) with
number [1].
The unit displays “- - - -”.
4) Press the numbered buttons (19) with
number [1] to [4], and enter the user ID.
Each button corresponds to each digit.
Enter the stored user ID.
5) Press the program type button (11) for
about 2 seconds or more to enter.
The power is turned off approx, 10 sec-
onds after “- - - -” is displayed.