Suzuki 2009 AN400, Дополнительное руководство по обслуживанию, Страница: 114 / 143

4E-72 ABS:
Rear Wheel Speed Sensor Removal and
Installation (AN400A/ZAK9)
B905H14506005
CAUTION
!
• The ABS is made up of many precision
parts; never subject it to strong impacts or
allow it to become dirty or dusty.
• The wheel speed sensor cannot be
disassembled.
Removal
1) Turn the ignition switch OFF.
2) Remove the side leg shield. Refer to “Side Leg
Shield Removal and Installation” in Section 9D in
related manual.
3) Remove the belt cooling duct and outer clutch cover.
Refer to “V-belt Type Continuously Variable
Automatic Transmission Removal and Installation” in
Section 5A in related manual and “Belt Cooling Duct
Hose Removal and Installation (AN400/A/ZAK9)” in
Section 5A (Page 5A-3).
4) Remove the frame cover. Refer to “Frame Cover
Removal and Installation” in Section 9D in related
manual.
5) Disconnect the rear wheel speed sensor coupler (1).
6) Remove the rear wheel speed sensor bracket
mounting bolt.
7) Remove the rear wheel speed sensor as shown in
the rear wheel speed sensor routing diagram. Refer
to “Rear Wheel Speed Sensor Routing Diagram
(AN400A/ZAK9)” (Page 4E-10).
8) Remove the rear wheel speed sensor (2) from the
bracket (3).
Installation
Refer to “Wheel Speed Sensor and Sensor Rotor
Inspection (AN400A/ZAK9)” (Page 4E-74).
Install the rear wheel speed sensor in the reverse order
of removal. Pay attention to the following points:
• Install the rear wheel speed sensor as shown in the
rear wheel speed sensor routing diagram. Refer to
“Rear Wheel Speed Sensor Routing Diagram
(AN400A/ZAK9)” (Page 4E-10).
• Check the clearance between the rear wheel speed
sensor and sensor rotor using the thickness gauge.
Special tool
(A): 09900–20803 (Thickness gauge)
(B): 09900–20806 (Thickness gauge)
Wheel speed sensor – Sensor rotor clearance
0.16 – 1.62 mm (0.006 – 0.064 in)
1
I905H1450056-01
I905H1450081-01
3
2
I905H1450057-01
(A), (B)
I905H1240009-02