Installation
Adjustment system - Installation Instructions
Page 22
6.3
Install Components
Note the exact information of the installation dimensions provided in the schematic diagrams
of the Height Adjustment System.
6.3.1
Installation in General
CAUTION
Electrical components (lifting elements, electrical controllers, manual switches)
should be connected or disconnected only with the power plug pulled out!
Bring the lifting elements in such a manner at the workplace that the load on the system is
balanced out (distributed uniformly).
Attach the lifting elements vertically and parallel to each other, so that they do not block each
other during lifting and lowering.
Keep electrical cord away from sharp edges and moving parts.
Avoid contact with moisture and heat.
Attach the electrical wires and power cords to the workstation or structure using cable ties or
clips.
IMPORTANT
When routing electrical cables, make sure that the cables are not stretched or
crushed. Position the cable such that stumbling is prevented. Use only accessories authorized and
provided by SUSPA.
The Height Adjustment System works properly only if it has been put into operation properly and
individual components are controlled correctly.
First check whether the individual components are damaged. If this is the case, do not put the
Height Adjustment System into operation, but have the damaged components replaced by
your supplier.
Also check the power cable for damage. Make sure to replace damaged power cables in any
case.