03/01/16
670- 00017B
3
installation. Do not attempt to disassemble system or system components for any reason.
If a defective component is found, contact Suspa
®
Incorporated for repair or replacement.
USE OF TRAINED AND QUALIFIED PERSONNEL System installation, operation,
and repair should only be done by persons having sufficient knowledge of the lift system
and the contents of this manual. In addition, they must have an understanding of all
warnings and precautionary measures noted in these safety instructions.
AVOID HAZARDOUS ENVIRONMENT. Do not operate the system outside. Do not
expose the system to damp or wet conditions. Avoid any chemical or corrosive
environments. Do not operate the system in the presence of flammable solvents,
propellants, and/or explosive materials (i.e. gas, vapor, dust, etc.) Avoid temperatures
outside of the system rated operating temperature range 41
°
to 113
°
F (5
°
to 45
°
C). Do
not subject lift system components to vibration and/or impact load conditions.
INSTALLATION SAFEGUARDS. Do not use the system for any purpose other than
its intended function. Before operating system, make sure that the workstation has a
minimum clearance of 2 in. (51mm) from any other object or structure to prevent
pinching or crushing hazards. Do not allow wall, cabinet, electrical lines, hydraulic or
pneumatic lines, or any other fixed structures to obstruct the movement of the
workstation during operation.
KEEP CHILDREN AWAY. It is not recommended that children operate this lift
device. If this device is used by or near children, close supervision is absolutely
necessary.
USE OF ACCESSORIES. Use only spare parts and accessories authorized or supplied
by Suspa
®
Incorporated. Do not replace or replenish lift system hydraulic fluid unless the
fluid is supplied by Suspa
®
Incorporated.
MAINTENANCE SAFEGUARDS. Prior to performing any maintenance or service on
the device, remove the load from all lift cylinders. The workstation or structure that the
lift system is attached to should be stabilized to prevent personal injury or property
damage during maintenance or service procedures.
RETRACT SYSTEM BEFORE MOVING. To reduce the risk of property damage and
personal injury, always retract the lift system fully before moving the equipment.
UNPLUG BEFORE CLEANING. Retract the lift system before cleaning components.
Clean system components with a mild soap and water-damped cloth. Do not use
corrosive cleaning agents or high pressure wash systems to clean lift system components.
Make sure system is clean and dry before operating the system.
SAVE THIS MANUAL FOR FUTURE REFERENCE.
