UPS-1000-Li-2 User Manual
© 2019 AMETEK Electronic Systems Protection / Technical Support: 1-800-645-9721 / surgex.com
4
6.
CONNECTING YOUR EQUIPMENT
Plug the mission critical equipment into the Battery & Surge output receptacles on the rear panel of the UPS-1000-Li-2.
Plug the noncritical equipment into the Surge Only output receptacles on the rear panel of the UPS-1000-Li-2. Ensure
that the connected equipment does not exceed the maximum output rating of the UPS-1000-Li-2 (refer to the information
label on the UPS-1000-Li-2 or the electrical specifications in this manual). DO NOT PLUG EXTENSION CORDS,
ADAPTER PLUGS, SURGE STRIPS OR POWER STRIPS INTO THE OUTPUT RECEPTACLES OF THE UPS-1000-Li-
2. NOTE: Risk of damaging the UPS-1000-Li-2 and/or connected equipment.
7.
USB COMMUNICATIONS PORT CONNECTION
(OPTIONAL)
This UPS-1000-Li-2 supports USB communications. The power monitoring software and interface cable can be used
with the UPS-1000-Li-2. Use only the interface cable that come with the UPS-1000-Li-2s. The USB communications
protocol is HID. The HID USB driver comes standard in the Windows OS. Simply connect the USB cable to the USB
communications port on the rear panel of the UPS-1000-Li-2. Connect the other end of the USB cable to the device that
will be monitoring/ controlling the UPS-1000-Li-2 and then follow the prompts on the screen.
NOTE:
When using the UPS-
1000-Li-2's USB port with Windows XP, 7 or 8 the Power Options in the Control Panel may need to be configured.
Connecting to the Communications Port is optional. The UPS-1000-Li-2 works properly without this connection.
8.
POWER MONITORING SOFTWARE
This product supports Power Monitoring Software. Please go to our web site at
https://www.ametekesp.com/surgex/ups-protection/ups-
protection-120-208v
then look under Downloads, and then Software to download..
IV.
OPERATION
1.
Turning the Equipment On/Off
To turn the UPS-1000-Li-2 on: press and hold the On/Off/Test Button until the alarm sounds one beep and then release. The
UPS-1000-Li-2 will perform a five second internal self-test. Once the UPS-1000-Li-2 has passed its internal self-test the UPS-
1000-Li-2 will provide an output and the load will be powered. To turn the UPS-1000-Li-2 off: press and hold the On/Off/Test
Button until the alarm sounds one beep and then release.
2.
Test Button
To perform a ten-second user invoked battery test: With the UPS-1000-Li-2 in the AC normal mode, press and hold the On/Off/Test Button
until the alarm sounds four beeps, and then release. During the test, the UPS-1000-Li-2 will switch to the Battery mode, the On-
Battery icon will illuminate and the alarm will sound.
3.
Alarm Silencer Button
When the unit is operating in Battery mode, pressing the Alarm Silencer Button will silence the audible alarm. Once the UPS-1000-Li-2
reaches the LBW (Low Battery Warning) threshold the alarm will be re-activated. The alarm cannot be silenced during the LBW alarm
or any fault condition. Once the UPS-1000-Li-2 transfers to the AC mode the alarm will be reset to default.
4.
Scroll Button
Press the Scroll Button to scroll through the UPS-1000-Li-2 parameters. The UPS-1000-Li-2 parameters are displayed on the
LCD screen.
