UPS-1000-Li-2 User Manual
© 2019 AMETEK Electronic Systems Protection / Technical Support: 1-800-645-9721 / surgex.com
2
II.
Controls and Indicators
1.
Control Panel
The AC normal icon illuminates when the UPS-1000-Li-2 is on and operating in the
AC normal mode. The AC normal icon will extinguish when operating in the
Battery mode. The AC normal icon will blink when it is operating in the Boost
mode.
The On-Battery icon illuminates when the UPS-1000-Li-2 is operating in the
Battery Mode. The On-Battery icon will extinguish when operating in the AC
normal mode and the Boost mode.
The Weak/Bad Battery icon illuminates when the UPS-1000-Li-2 detects a
weak battery, bad battery or if the battery is disconnected. The Weak/Bad
Battery icon is extinguished when the battery's condition is good.
The Fault icon illuminates when the UPS-1000-Li-2 detects an internal fault.
The Fault icon is extinguished when the UPS-1000-Li-2 is operating properly.
The Site Wiring Icon illuminates when the UPS-1000-Li-2 detects a site wiring problem. The SWF icon is
extinguished when the UPS-1000-Li-2 is connected to proper site wiring.
Load Capacity Bar Graph: Displays the amount of load connected to the UPS-1000-Li-2 in the AC and Battery mode as
20%, 40%; 60%, 80%,100%.
When the amount of load attached to the UPS-1000-Li-2 exceeds 110% of its power rating; the Overload icon will flash Off
and On, all of the LEDs in the Load Level Bar Graph will be illuminated and the UPS-1000-Li-2 will sound a constant alarm
to indicate that there is an Overload condition.
Battery Capacity Bar Graph: Displays the amount of Battery Capacity available in the AC and Battery mode as 20%, 40%;
60%, 80%, 100%.
UPS-1000-Li-2 Parameters:
•
Input - Voltage and Frequency
•
Output - Voltage and Frequency
•
KVA - Kilo Volt Amperes
•
KW - Kilowatts
•
Estimated Runtime (minutes) - AC normal and Battery mode.
The Multi-Function On/Off/Test Button functions as follows: When the UPS-1000-Li-2 is Off, press and release the
On/Off/Test button after one beep to turn the UPS-1000-Li-2 On.
When the UPS-1000-Li-2 is On, press and release the On/Off/Test Button after one beep to turn the UPS-1000-Li-2 Off.
When the UPS-1000-Li-2 is in the Normal AC mode, press and hold the On/Off/Test button for four beeps, then release the
button. The UPS-1000-Li-2 will perform a 10-second Self-Test.
When the unit is operating in Battery mode, pressing the Alarm Silencer Button will silence the audible alarm. Once the
UPS-1000-Li-2 reaches the LBW (Low Battery Warning) threshold the alarm will be re-activated. The alarm cannot be
silenced during the LBW alarm. Once the UPS-1000-Li-2 transfers to the AC mode the alarm will be reset to default.
