10
LOADING: Bag in Box
·
Product is supplied in a sanitary prepackaged bag in a box that fits into the refrigerated
product compartment of the dispenser.
·
Sanitize your hands or wear clean gloves to install the bag in box and delivery tube.
1.
Open the door to the refrigerated compartment.
2.
Open the valve door by unscrewing the black
knob in a counterclockwise motion to loosen
the screw.
3.
Load the bag in box dairy product into the
refrigerated product compartment on the
Product Box Ramp, with the product delivery
tube facing out to the front and centered in the
dispensing valve.
4.
Make sure there are no kinks or twists in the
product delivery tube.
5.
Align the product delivery tube in the central
vertical groove of the valve block. Do not pull
or stretch the product delivery tube.
6.
Close the valve door, making sure the product
delivery tube is in the vertical groove and is not
kinked or pinched.
7.
While holding the valve door closed with one
hand, tighten the knobscrew in a clockwise
motion until the door is snug.
Do not over
tighten the screw.
8.
Squeeze the product delivery tube just below
the valve with all fingertips.
9.
PC Dispensers: While squeezing the tube,
press the “small” product quantity button on the
front door button panel
once
only. This will
cause the valve to operate once and relieve
pressure in the tube.
SS Dispensers: While squeezing the tube,
hold the lever down to relieve pressure in the
tube.
10.
Use sharp scissors to carefully cut the product
delivery tube at a 45° angle at a maximum
length of 5/8” from the bottom of the valve
block. Discard the cut portion of the tube.
12.
Close the refrigerated product compartment
door.
The dispenser is ready for use.
