SureShot AC-LC2, Руководство по эксплуатации

Страница: 9 / 16

AC-LC2 Liquid Cooler Dispenser
•
SureShot Technical Assistance Center: 888 777-9990 or +1 902 865 9602
5
PRESSURE REGULATOR
The amount of cooling water used for the cooling process can be adjusted.
Adjustment may be required to increase cooling water due to variances in local
water temperature.
1. Turn the power switch to OFF. The power switch is located on the right side of
the dispenser toward the back, near the bottom.
2. Remove six (6) screws from the back of the dispenser.
3. Remove panel. Set aside.
4. Locate pressure regulator inside the back of the dispenser on the bottom.
5. Loosen locknut and adjust pressure as required. See Figure 3.

Turn clockwise to increase pressure for more cooling.

Turn counter-clockwise to decrease pressure for less cooling.
Note: Changing pressure regulator to increase cooling water will increase cold
water consumption.
CLEANING

Do not use any abrasive material or cleaners on the dispenser.

Dispenser must not be cleaned by water jet.

Do not spray any liquid or cleaners in or around the inside of the dispenser. Liquid could damage
electrical components of the dispenser.

Dispose of liquids flushed through dispenser during cleaning procedure.

When flushing dispenser during cleaning procedure, use an appropriately sized catch container
that can easily be handled, as it may contain hot liquid. It may be necessary to stop flow after
partial drainage. Empty the container each time it is filled and continue draining as required.
Recommended Cleaning Schedule
Equipment Procedure Frequency
Exterior of Dispenser See page 5 Daily
Tanks, Heat Exchanger, Screen,
Dispense Faucet and Lines
See page 5 Daily
Sanitizing and Destaining See page 6 Weekly
Exterior
1. Wipe exterior surfaces using a soft cloth dampened with warm, clean and soapy water.
A stainless steel cleaner is recommended for use on stainless steel surfaces only.
Note: Do not allow stainless steel cleaner to come in contact with the plastic faucet.
2. Rinse with warm, clean water.
Tanks, Heat Exchanger, Screen, Dispense Faucet and Lines
Daily Cleaning
1. Ensure green LED indicator light is solid and not flashing.
2. Turn
off power switch.
3. Open dispense faucet and drain any remaining product into an appropriately sized catch
container. Discard drained product.
a. Open dispense faucet by tilting lever into the lock position.
Lever can be tilted both directions.

Tilting lever fully in one direction to a horizontal position locks the faucet open.

Tilting lever in the opposite direction allows it to close automatically when released.
Pressure
Regulator
Figure 3