SureShot AC-LC2, Руководство по эксплуатации

Страница: 8 / 16

AC-LC2 Liquid Cooler Dispenser
•
SureShot Technical Assistance Center: 888 777-9990 or +1 902 865 9602
4
INSTALLATION
Plumbing
Note: A certified plumber is required for installation.
Note: See page 3 for Electrical and Water Requirements.

The length of the outlet and drain line is not critical.

Outlet and drain line diameter must not be smaller than
specifications on page 3 by changing line, adding fittings or
couplers, kinking, crimping or pinching. See Figure 2.

Increasing outlet and drain line diameter is acceptable.

The orientation of the outlet and drain line must always slope
away from the dispenser.

Plumbing must meet local codes and requirements.
OPERATING THE DISPENSER
Turning on the Dispenser
1. Plug the power cord from the dispenser into an AC electrical wall outlet.
2. Turn power switch to ON. Power switch is located on the right side of dispenser toward the back,
near the bottom. A green LED light on the front, left side of the dispenser will illuminate to
indicate the power is ON.
Loading Product
1. Ensure green LED indicator light on front, left side of dispenser is solid and not flashing.

Flashing: Product is cooling

Solid: Product is cooled and ready for use

Not Illuminated: No power
2. Open the lid on top of the dispenser by lifting it up and towards the back.
3. Pour up to 2 pots of hot liquid into top tank of dispenser.
Note: Do not pour more than 2 pots of liquid into the dispenser at a time, as it may overflow.
4. Liquid will flow from the top tank, through the heat exchanger located inside the dispenser and
then into the bottom tank. Two pots will take approximately 3 minutes.
Caution: Always check product indicator level on bottom tank prior to pouring additional hot liquid
into top tank. Ensure bottom tank will accommodate additional amounts of hot liquid being poured
into dispenser to avoid overflow.
Dispensing Product
1. Hold or place cup under dispense faucet.
Note: Maximum cup height is 8" or 20cm.
2. Pull or push dispense lever to dispense cooled liquid.
3. Return lever to upright position when desired quantity has been dispensed.
Inlet Outlet
Figure 2