SureShot AC-LC2, Руководство по эксплуатации

Страница: 7 / 16

AC-LC2 Liquid Cooler Dispenser
•
SureShot Technical Assistance Center: 888 777-9990 or +1 902 865 9602
3
Install Screen
Note: The screen is shipped inside the top tank and must be installed
correctly.
1. Locate screen.
2. Set the screen inside top tank at the front.
3. Ensure the tab on the screen is facing the front.
4. Attach tab to the front of the top tank. This is to hold the screen in
place. See Figure 1.
DISPENSER REQUIREMENTS
Safety Precautions

Always plug the dispenser into an approved electrical outlet.

The dispenser includes a microcontroller and must be operated on grounded electrical wiring at
all times.

Unplug the dispenser from its electrical source before servicing.

Do not immerse the dispenser in water.

Observe all safety precautions with this dispenser that you would with any electrical appliance.

Always use caution when working with hot liquids.
Electrical and Water
Power: 120 V AC, 60 Hz, 0.15 amp, 1 ph
Water: Cold water supply line with a minimum of 6 liters (1.5 gallons) per minute
Water pressure should be between 25
–
75 psi
Inlet: 0.25" Male S.A.E. 45° Flare Fitting included with dispenser
Note: The inlet also accepts 3/8 " OD x 1/4 " ID Low Density Polyethylene Tubing
by removing the 1/4 " flare fitting and tube.
Outlet: 3/8" OD x 1/4" ID
Access to free drain
Note: A certified plumber is required for installation. See page 4.
Locating the Dispenser in your Facility

This dispenser is not suitable for outdoor use.

Place the dispenser where it will best serve your operation.

Place the dispenser at the appropriate serving height so that users of the dispenser can operate
the dispense faucet, easily place and remove cups, and can comfortably pour liquid into the top
tank.

Do not place the dispenser too close to a source of heat or moisture.

The dispenser should be placed on a level surface. The dispenser does not require levelling for
normal operation.

Counters, platforms, or shelves should be strong enough to support the dispenser and a full
product load. The empty dispenser weighs 42 lb.
/ 19 kg. The full dispenser weighs 50 lb. / 23 kg.
Figure 1