Sureshot Dispensing Systems AC2-GP, Руководство по эксплуатации

Страница: 14 / 28

AC2-GP Multi-Sweetener Dispenser
•
SureShot Technical Assistance Center: 1-888-777-9990 or 902-865-9602
10
OPERATING INSTRUCTIONS
Note: Before starting dispenser, ensure all dispenser requirements (page 3), cleaning
(page 5) and set-up (page 9) instructions have been followed.
Button Panel
–
Disabling and Enabling
When opening the door for any reason, it is recommended that you disable the button
panel.
1. Disable button panel.
a. Press and hold the

Panel Disable button on the button panel for 3 seconds
until beeps are heard. Lights on the button panel will flash in sequence.
2. Enable button panel.
a. To enable the button panel, press and hold the

Panel Disable button on the
button panel for 3 seconds until a beep is heard.
Note: Button panel will enable automatically after 3 minutes of being disabled.
Opening the Dispenser Door
1. Grasp door on the
top right corner
and swing out until
the door is opened
fully (180°).
This permits
access to the
inside of the
dispenser for easy
loading or removal
of hoppers.
Product Hoppers
Each dispenser holds two hoppers
–
top and bottom.
The bottom hopper is smaller and is intended for lower volume sweeteners or products.
Each hopper includes an auger that draws the product from the hopper for dispensing.
Hoppers are installed and removed, with no tools required, by sliding them in or out of the
product compartment. They are designed to automatically fit and connect with the auger
motor.
WARNING: The dispense auger is powered by a motor with a turning shaft.
To avoid possible injury or equipment damage, keep hands and objects clear
of the auger and shaft when equipment is plugged in.