SureKap SK6000-BF6, Инструкция по эксплуатации

Страница: 15 / 67

Carla / My Documents
13
Rev. Date: 24 August 2018
“SK6000-BF6 Capper Manual-word document (master) ”
F & G
F. SPINDLE DISC IN/OUT (1st Set)
Measure the distance between the inside of the cage face plate and the cage block on the
operator’s side. The purpose of the 1st spindle set is to start the cap onto the container
threads. The spindle moves in and out, on center, by turning the appropriate knob. The
tightening discs only need to lightly touch the sides of the cap. If there is too much pressure,
you may not be able to start the cap on the threads. The spindle speed will need to be
adjusted so that the tightening disc spins the cap down completely until the cap is fully
seated.
Step 1: Adjust the 1
st
set of spindles (by turning the spindle knob) until the 1
st
set of
tightening discs lightly touch the sides of the cap.
Step 2: Turn on the conveyor and gripper belts. Turn on the spindles.
Step 3: Place your container on the conveyor and run it through the capper. The 1
st
set of
spindles should screw the cap down on the container (not tighten the cap). Adjust
accordingly, if needed. Secure the spindle knob with the lock knob.
G. CLUTCHED DISC IN/OUT
Measure the distance between the inside of the cage face plate and the cage block on the
operator’s side. Clutches have been installed on the 2
nd
and 3
rd
set of spindles. When
adjusted properly, the clutches will stop the spindle and tightening disc from spinning after
applying the desired amount of torque to the cap. Increased cap torque can be achieved by
adjusting the mechanical clutches (with the machine turned off) by turning the knurled ring
(with your fingers) clockwise to increase torque; counter-clockwise to decrease torque. A
small adjustment makes a big difference in performance. When turning the knurled ring, you
can feel it “click”. Count the “clicks” so you can set each side equally.
CAUTION: Do not
attempt to adjust the clutch with the machine and/or spindles on.