SureCall | 48346 Milmont Dirve, Fremont CA 94538 | 1-888-365-6283 | [email protected]
14
Installing your Hardware
Step 5. Configure Gain Settings
1. Find the PCS and Cellular on the top of the signal booster (See above ).
2. Set the dials according to the coverage area and the distance between the indoor and
outdoor antennas (see next page).
Lighting type
Green light
Yellow light
Yellow light blinking
Indication
ON: Power up.
OFF: No power.
ON: Uplink inactivity in that band.
OFF: Working properly.
Blinking: AGC operating.
OFF: Working properly.
Red light blinking: Adjusting
for oscillation.
OFF: Working properly.
Red light and yellow light
blinking: Self-oscillating.
OFF: Working properly.
Red light blinking
Red light yellow light
alternately blinking
Booster Hardware
The following image shows the key hardware components on the cellullar booster.
Refer to this image as you install your FlexPro kit components.
Cellular - 800 Dial
PCS - 1900 Dial
Alert LED
Alert LED
Power Jack
FME connector to inside antenna
Programmer
Power Switch
FME connector to outside antenna
