SureCall | 48346 Milmont Dirve, Fremont CA 94538 | 1-888-365-6283 | [email protected]
13
Installing Your Hardware
Step 4. Install the Signal Booster
1. Select a location close to a working AC outlet. Do not expose the signal booster to
excessive heat, direct sunlight, moisture, and airtight enclosures. In areas where there
are higher temperatures, install the booster vertically, so air can move between the metal
channels on the faceplate.
2. If you’d like to mount the booster to a wall, mark location of screw tabs on the wall in
the desired location.
3. Use supplied screws or appropriate screws for surface of mounting location and drill
through screw tabs holes on boosters.
4. Connect the outside antenna cable to the signal booster connector marked
OUTSIDE
(see page 14). Hand-tighten the connection.
5. Connect the inside antenna cable to the signal booster connector marked
INSIDE
(see
page 14). Hand-tighten the connection.
6. Connect the AC power cord to the signal booster (see page 14).
7. Connect the plug on the other end of the 110V AC power outlet.
8. Turn the booster’s power switch on.
• The signal booster turns on automatically.
• The
Power
LED lights up to show that the signal booster is ready for use see page 14.
• The
Alert
LED flash up to 15 seconds on each band to show the band is activated see
page 14.
Note
:
If the Power LED does not turn ON or the Alert LEDs continue to flash, see Troubleshooting page 15.
This booster is rated for 5-15V input voltage. DO NOT use the booster with a higher voltage power supply. This can damage the booster, cause
personal injury, and void your warranty.
