Heatseeker UniPanel®
Solar Pool Heating
15
Starting the Pump
To operate efficiently and to prevent damage to the pump there must be a free flow of water to
and from the pump. Before starting ensure that:
• All pipe work is correctly sealed.
• The pool/spa water level is at the correct height.
• That all appropriate valves are open and there is nothing preventing the flow of water
through the system.
STARTING THE SS SERIES SOLAR PUMP
STEP 1
First prime the pump by removing the strainer basket lid and filling the strainer basket area with water.
Replace the lid, ensuring that it seals on the large O-ring.
STEP 2
Connect to the power supply and switch on.
STEP 3
Allow the pump to run, so that any air trapped in the pipe work and pump may be expelled.
STEP 4
If prime is not established within approximately 2 minutes, as evidenced by a strong flow of water from the
outlet, switch off the pump and repeat the procedure. Continued evidence of air under the hair and lint pot lid
indicates an air leak in the suction pipe work, which should be rectified to avoid pump damage.
Pump Operation
For optimum pump performance, the strainer basket housing should always be full of water and
free from air bubbles.
The water level of the pool should always be maintained to at least halfway up the skimmer box
ensuring water is in the pump at all times. From time to time it may be necessary to re-prime the
pump. This should be carried out as described above.
Water Quality
Maintaining balanced water chemistry is important to the life of your pump. Please consult your
local pool shop regularly to have your water tested.
