Supero X7DCT-3, Руководство пользователя

Страница: 55 / 93

Chapter 2: Installation
2-33
2-9 Serial_Link Connections
Note the following conditions when connecting the Serial ATA and fl oppy disk drive
cables:
• Be sure to use the correct cable for each connector. Refer to Page 1-1 for cables
that came with your shipment.
• A red mark on a wire indicates the location of pin 1.
SATA Connectors (X7DCT-L/-LF)
Four Serial_Link connections are confi gured as
four Serial ATA (SATA) connectors (I-SATA 0~3)
on the X7DCT-L/-LF. Serial Link connections
provide faster data transmission than those of
the traditional Parallel ATA. These SATA connec-
tors are supported by the Intel ICH9R. See the
table on the right for pin defi nitions.
SATA Connectors
Pin Defi nitions
Pin# Signal
1 Ground
2 SATA_TXP
3 SATA_TXN
4 Ground
5 SATA_RXN
6 SATA_RXP
7 Ground
SAS Connectors (X7DCT-3/-3F/3IBXF)
The same four Serial_Link connections indicated above are confi gured as SAS
connectors (0~3) on the X7DCT-3/-3F/-3IBXF. These connectors provide faster data
transmission than those of the traditional Parallel ATA. These SAS connectors are
supported by the LSI 1064E MegaRAID Controller.
Note: For more information on the LSI SAS MegaRAID confi guration,
please refer to the LSI MegaRAID User's Guide posted on our website @
http://www.supermicro.com/support/manuals/.
X7DCT-L
Rev. 1.2
A
A. SATA 0~3 (X7DCT-L/-LF)
A. SATA 0~3 (X7DCT-3/-3F/3IBXF)