Supero X6DAL-XTG, Руководство пользователя

Страница: 85 / 126

Appendix C: Software Installation
C-1
C-1 Introduction to the Adaptec Embedded Serial ATA
RAID Controller Driver
Serial ATA (SATA)
Serial ATA(SATA) is a physical storage interface. It uses a single cable with
a minimum of four wires to create a point-to-point connection between
devices. It is a serial link which supports SATA Transfer rates from
150MBps. Because the serial cables used in SATA are thinner than the
traditional cables used in Parallel ATA(PATA), SATA systems have better
airflow and can be installed in smaller chassis than Parallel ATA. In addition,
the cables used in PATA can only extend to 40cm long, while Serial ATA
cables can extend up to one meter. Overall, Serial ATA provides better
functionality than Parallel ATA.
Introduction to the Intel 6300ESB (Hance Rapids) I/O
Controller Hub
Located in the South Bridge of the Intel E7525 Tumwater Chipset, the 6300ESB
(Hance Rapids) I/O Controller Hub provides the I/O subsystem with access to
the rest of the system. It supports 2-channel Ultra ATA/100 Bus Master IDE
controller (PATA) and two Serial ATA (SATA) Host Controllers, which support
up to two Serial ATA ports and up to two RAID drives. The 6300ESB (Hance
Rapids) I/O Controller Hub supports the following Parallel ATA (PATA) and
Serial (SATA) device configurations:
Appendix C
Installing Software Drivers and Windows
Operating System
After all the hardware has been installed, you must first configure the
Adaptec Embedded Serial ATA RAID Driver before you install the Windows
operating system. The necessary drivers are all included on the Supermicro
b o o t a b l e C D s t h a t c a m e p a c k a g e d w i t h y o u r m o t h e r b o a r d . ( F o r t h e
information on Adaptec's SATA HostRAID Utility based on Marvell's chip,
please refer to Appendix D.)