Supero X10SLE-DF, Руководство пользователя

Страница: 50 / 95

3-2
X10SLE-DF User’s Manual
No Video
1. If the power is on, but you have no video, you will need to remove all the
add-on cards and cables first.
2. Use the speaker to determine if any beep codes exist. (Refer to Appendix A
for details on beep codes.)
3. Remove all memory modules and turn on the system. (If the alarm is on,
check the specifications of the memory modules and reset the memory or try
a different one.)
Memory Errors
1. Make sure that the DIMM modules are properly installed and fully seated in
the slots.
2. You should be using unbuffered ECC DDR3 (1.5V) 1600/1333/1066 MHz VLP
(Very-Low-Profile) memory as recommended by the manufacturer. Also, it is
recommended that you use memory modules of the same type and speed for all
DIMMs in the system. Do not use memory modules of different sizes, different
speeds, or different types on the same motherboard.
3. Check for bad DIMM modules or slots by swapping modules between slots to
see if you can locate the faulty ones.
4. Check the switch of 115V/230V power supply.
Losing the System’s Setup Configuration
1. Please be sure to use a high-quality power supply. A poor-quality power
supply may cause the system to lose its CMOS setup information. Refer to
Section 1-5 for details on recommended power supplies.
2. The battery on your motherboard may be old. Check to verify that it still sup-
plies ~3VDC. If it does not, replace it with a new one.
3. If the above steps do not fix the Setup Configuration problem, contact your
vendor for repairs.