Supero X10SLE-DF, Руководство пользователя

Страница: 40 / 95

2-20
X10SLE-DF User’s Manual
MAC CODE MAC CODE
BAR CODE
JKVM1
LE5
LED7
LE6
JBT1
JBT2
J10
P1-JPG1 P1-JWD1
JPV1
J3
J4
P2-JPG2
J7
J2
JPV2
P1-JPME1 P1-JPME2
P2-JPME2
P1-JPME2
J38
J37
SW2
J9
P2-DIMMA2 P2-DIMMB1 P2-DIMMB2
P2/P1-LAN1
MAC CODE MAC CODE
P1-POR
T80
PLED2 PLED1
P2/P1-LAN2
SW NODE
USB0/1
Battery
P2-POR
T80
IPMI_LAN
PWR
CPU2
CPU1
P2-DIMMA1
P1-DIMMB2
P1-DIMMB1 P1-DIMMA2 P1-DIMMA1
BT
SW1
X10SLE-DF
Rev. 1.01
LAN
CTRL
LAN
CTRL
BMC BMC
BMC
Firmware
BMC
Firmware
BMC
Memory
BMC
Memory
LAN
Switch
Node
Switch
PCH
PCH
J8
(SMC-Proprietary
Add-On Card Slot)
P2-JWD1
B
2-8 Jumper Settings
Explanation of Jumpers
To modify the operation of the mother-
board, jumpers can be used to choose
between optional settings. Jumpers create
shorts between two pins to change the
function of the connector. Pin 1 is identified
with a square solder pad on the printed
circuit board.
Note: On two-pin jumpers,
"Closed" means the jumper is on,
and "Open" means the jumper is
off the pins.
A. Clear CMOS for Node 1 (JBT1)
B. Clear CMOS for Node 2 (JBT2)
Clear CMOS (JBT1)
JBT1 is used to clear the saved system setup configuration stored in the CMOS
chip for Node 1, while JBT2 is used for Node 2. To clear the contents of the CMOS,
completely shut down the system, remove the AC power cord connection, and
then short JBT1 or JBT2 with a jumper. Remove the jumper before powering on
the system again. This will erase all user settings and revert everything to their
factory-set defaults.
A