Supero SuperWorkstation 7046A-HR+, Руководство пользователя

Страница: 47 / 112

Chapter 5: Advanced Serverboard Setup
5-13
Reset Button
The Reset Button connection is
located on pins 3 and 4 of JF1 and
attaches to the reset switch on the
computer chassis. See the table on
the right for pin de
fi nitions.
Power Button
The Power On connection is on pins
1 and 2 of JF1. These should be
connected to the chassis power but-
ton. See the table on the right for pin
de
fi nitions.
5-9 Connector De fi nitions
Required Connection
Required Connection
ATX Power 24-pin Connector
Pin De fi nitions
Pin# De fi nition Pin # De fi nition
13 +3.3V 1 +3.3V
14 -12V 2 +3.3V
15 COM 3 COM
16 PS_ON 4 +5V
17 COM 5 COM
18 COM 6 +5V
19 COM 7 COM
20 Res (NC) 8 PWR_OK
21 +5V 9 5VSB
22 +5V 10 +12V
23 +5V 11 +12V
24 COM 12 +3.3V
Reset Button
Pin De fi nitions (JF1)
Pin# De fi nition
3 Reset
4 Ground
Power Button
Pin De fi nitions (JF1)
Pin# De fi nition
1 Power Signal
2 Ground
Processor Power Connector
JPW2 and JPW3 must also be con-
nected to the power supply. See the
table on the right for pin de
fi nitions.
Main ATX Power Supply
Connector
The primary power supply connector
(JPW1) meets the SSI (Superset ATX)
EPS 12V speci
fi cation. Refer to the ta-
ble on the right for pin de fi nitions. You
must also connect the 8-pin (JPW2/
JPW3) processor power connectors to
your power supply (see below).
Processor Power Connectors
Pin De fi nitions
Pins De fi nition
1 - 4 Ground
5 - 8 +12V
Warning: To prevent damage to the power supply or serverboard, please use a
power supply that contains a 24-pin and two 8-pin power connectors. Be sure to
connect these connectors to the 24-pin (JPW1) and the two 8-pin (JPW2,JPW3)
power connectors on the serverboard. Failure in doing so will void the manufacturer
warranty on your power supply and serverboard.