Supero SuperWorkstation 7046A-HR+, Руководство пользователя

Страница: 37 / 112

Chapter 5: Advanced Serverboard Setup
5-3
•
SATA drive data cables (I-SATA0 ~ I-SATA5)
•
Control Panel cable (JF1)
•
USB cable for front side access (USB6/7)
Important! Make sure the the cables do not come into contact with the fans.
Connecting Power Cables
The X8DAH+/X8DAH+F has a 24-pin primary power supply connector (JPW1) for
connection to the ATX power supply. In addition, there are two 8-pin 12V processor
power connectors (JPW2 and JPW3) that must be connected to your power supply.
See Section 5-9 for power connector pin de
fi nitions.
Connecting the Control Panel
JF1 contains header pins for various front control panel connectors. See Figure 5-1
for the pin locations of the various front control panel buttons and LED indicators.
All JF1 wires have been bundled into a single cable to simplify this connection. Make
sure the red wire plugs into pin 1 as marked on the board. The other end connects
to the Control Panel PCB board, located just behind the system status LEDs on
the chassis. See Chapter 5 for details and pin descriptions.
Figure 5-1. Control Panel Header Pins
NMI
x (Key)
Vcc
Vcc
Vcc
Vcc
Vcc
Vcc
Reset (Button)
Power (Button)
Ground
x (Key)
Power On LED
HDD LED
NIC1 LED
NIC2 LED
OH/Fan Fail LED
Power Fail LED
Ground
Ground
2 1
20 19