Supero SuperWorkstation 7046A-HR+, Руководство пользователя

Страница: 42 / 112

5-8
S
uper
W
orkstation 7046A-HR+/7046A-HR+F User's Manual
Memory Support
The X8DAH+/X8DAH+F supports up to 144 GB of DDR3 1333/1066/800 registered
ECC SDRAM in 18 DIMM slots. Three-way interleaved memory is supported. For
optimal memory performance, install DIMMs three at a time. Use memory modules
of the same type and speed. See the following table for memory installation.
DIMM Installation
Installing Memory Modules
1. Insert the desired number of DIMMs into the memory slots, beginning with
CPU DIMM #1A and DIMM #2A, etc. (see Memory Con fi guration Table be-
low). Always spread DIMMs across all three banks for each CPU (see Figure
5-4).
2. Insert each DIMM module vertically into its slot. Pay attention to the notch
along the bottom of the module to avoid installing incorrectly (see Figure 5-3).
3. Gently press down on the DIMM module until it snaps into place in the slot.
Repeat for all modules.
!
CAUTION! Exercise extreme care when installing or removing DIMM
modules to prevent any possible damage.
5-6 Installing Memory
To Install: Insert module
vertically and press
down until it snaps into
place. Pay attention to
the alignment notch at
the bottom.
To Remove:
Use your thumbs to
gently push the release
tabs near both ends of
the module. This should
release it from the slot.
Figure 5-3. DIMM Installation
Top View of DDR3 Slot
Release Tab
Release Tab
Note: Notch should align
with the receptive key
point on the slot.
Notch
Notch
Front View